RG #011 - DESTINY GUNDAM

Bandai - BAN

$31.00

The head can swivel/tilt on a ball-and-socket/hinge neck joint.
The torso can tilt frontwards/backwards.
Shoulder joints can pull out and swing frontwards or raise upwards.
The arms can swing and/or raise horizontally on an integrated shoulder frame.
The upper arms can rotate.
Arms and Legs feature double-jointed elbow/knee parts.
The manipulators...
- Can swivel on a ball-and-socket joint.
- Feature 3+1+1 articulation on the poseable fingers.
The waist can rotate 360 degrees.
Front, side, and rear skirt armors can lift up to avoid interference with the leg articulation.
The hip joint axis can tilt forward. (This position can be locked with the front crotch piece.)
The upper thighs can swing on a peg-and-socket joint, raise horizontally, and/or rotate on each piece.
The ankle joints can pivot, or tilt sideways in some extent.
The 2-piece front feet can pivot.
The wings are jointed, allowing some articulation.
The Beam Sword and Beam Cannon racks are jointed, allowing some articulation.

Cockpit hatch can open.
The hands are swappable.
Each of the weapons must be wielded by their respective hand parts.
Beam Boomerangs can be optionally detached from the shoulders as handheld weapons.
Beam Rifle's foregrip can swivel left or right.
- Beam Rifle can mount onto the rear waist armor for storage.
Beam Sword can be optionally removed from the weapon rack as a handheld weapon.
Long-Range Beam Cannon can be wedged out with the weapon rack to form firing mode.
The Anti-Beam Shield can...
- attach onto either of the forearms.
- be expanded.
The Beam Shield can attach onto either of the forearms.
Destiny Gundam can mount onto the Action Base (sold separately) via an adapter.

For better results, some of the details are needed to be panel-lined with Gundam markers.
Topcoat (Mr. Hobby recommended) can be used to protect applied decals. (Water-based topcoat is recommended due to the kit having PP parts)
- If using matte/flat-finish top coat, it is advisable not to spray on the clear/translucent parts - can be done by masking or spraying top coat while the said parts are separated.