HGUC #167 Gundam F91

Bandai - BAN

$15.00

Current Stock:

Out of stock

The head can swivel/pivot on a double-sided ball-joint neck.
The torso can slightly tilt sideways/pivot back and forth.
Due to its construction, the arms can...
- Raise upwards on a shoulder joint socket.
- Swivel on a ball-and-socket joint.
- Raise horizontally on the shoulder armors.
The upper arms can rotate.
The elbow and knees are double-jointed.
The manipulators can swivel on a ball-and-socket joint.
The waist can rotate 360 degrees.
Front and side skirt armors can pivot to avoid interference with the leg articulation.
The hip joint axis is a see-saw-type joint.
The upper thighs can swing frontward (and backward in a very limited extent due to the non-poseable rear skirt armor), raise horizontally and/or rotate on each piece.
Ankle joints can slightly tilt/pivot.
The V.S.B.R.s are attached on a joint arm, allowing some articulation.

The heads can interchange between two modes.
The hands are swappable.
Each of the weapons must be wielded by their own respective hand parts.
The heat radiation fins can be swapped.
The radiation panels on the rear lower legs can be flipped out.
The V.S.B.Rs can wedge out, slide frontwards and flip down the handles to create firing mode.
Beam Rifle foregrip can swing left or right.
Beam Bazooka's handle can pivot front or back.
Beam Bazooka can be mounted onto the rear waist.
Beam Shield + Generator can be mounted onto the left forearm via parts swapping.
Gundam F91 can mount onto any Action Bases. (sold separately)

For better results, some or most of the details are needed to be painted and panel-lined with Gundam Markers and/or Mr. Color Paints.
Topcoat (Mr. Hobby recommended) can be used to protect applied stickers and if any, marking decals and painted details.
- If using matte/flat-finish top coat, it is advisable not to spray on the translucent parts - can be done by masking or spraying top coat while the said parts are separated.