Product Description
Includes
- Unicorn Gundam 03 Phenex (Unicorn Mode)
- 1 pair of Armed Armor DEs
- Tail units
- 4 Beam Saber hilts
- 2 Beam Saber effects
- Manipulators
- Weapon-holding (1 pair)
- Trigger-finger (right)
- Open-palm (1 pair)
- 1 pair of Armed Armor DEs
- Hyper Bazooka
- Storage mode parts
- Hyper Bazooka Magazine
Kit Features & Gimmicks
Articulation
- The head can pivot up/down on a hinge and swivel on a ball-joint neck.
- The shoulder joints can slightly raise upwards and/or slightly swing forwards/backwards.
- The arms can...
- Swing on a peg-and-socket joint.
- Raise horizontally.
- The upper arms can rotate.
- Both elbow and knee joints can be bent up to 90 degrees.
- The manipulators can swivel on a ball-and-socket joints.
- Front and side skirt armors can pivot to avoid interference with the leg articulation.
- The waist can swivel on a ball-and-socket joint construction.
- The hip joint axis can swing frontwards/backwards on one side.
- The upper thighs are swivel on a ball-and-socket joint construction, though the backwards articulation is limited due to the non-poseable rear skirt armors.
- The ankles can slightly tilt forwards/backwards, or sideways.
- The Armed Armor DEs can rotate on a backpack joint.
- The "Tail" stabilizers are poseable.
Weapons/Other Gimmicks
- The hands are swappable.
- Each of the weapons must be wielded by their own respective hands.
- Hyper Bazooka can convert between attack or storage modes via parts swapping or mount onto the backpack via a flip-out tab.
- Beam Saber hilts can be optionally removed from their respective racks as handheld weapons.
- Hyper Bazooka Magazine can be stored onto the right rear waist armor.
- The shield can be stored onto the backpack via an adapter (A18).
- Unicorn Gundam can mount onto any Action Bases. (sold separately)
Tips & Tricks
- Due to the parts being coated along with the runner (and combined with a lack of undergates), cutting the pieces off from the sprues may leave some marks, even if some care is taken.
- Likewise, some parts' latches/notches can be in a tight fit while assembling, so some scraping is needed.
- If one wishes to panel-line the coated parts, use the water-based Gundam Marker GM20 black instead.
- If one chooses, the Gunpla can be built into the original Phenex (sans the stabilizers) by using the included surplus pieces and some extra polycaps.
- The Gundam UC ACE Vol.6 exclusive Hyper Beam Javelin, the Hyper Beam Javelin from the System Weapon 007 can be used for this kit.
- Care must be taken while separating the hand parts: Due to its slightly tight construction, the pin that connects the thumb section can potentially snap off if you separate it with excessive force.
- The clear parts from The Gundam Base exclusive variant can be used to swap the blue Psycoframe parts to recreate the deactivated Psycoframe version of the unit.